BATTERY BACKUP
TECH SPECS
Chemical System: Nickel Iron (NiFe)
Electrolyte Chemistry: Environmentally safe Potash Electrolyte Mineral Fluid
Electrolyte Refresh Rate: Suggested every 7-10 years for maximum performance
Terminal Poles Cell-to-Cell Bus: Nickel, Copper
Vents: Arresting Flip Vents and Hydrogen Harvest
Nominal Voltage per cell: 1.35 2.8 Volts high-charge
Charging Voltage per cell: High-charge
Cycle Life: Unlimited Charge Cycles
Shelf Life: 85 years
Operating Temp: -60 to +200 F
Warranty: Lifetime
Technical Support: unlimited for the life of Battery
​
Attributes
No explosion even in short
No noxious chemicals
High tolerance to abuse
100% recovery of capacity
Zero toxicity
Completely recyclable
No reverse polarity conditions
Large capacity — 600,000 Ah
4MW high-density in a single container
No required cooling
No rapid voltage discharge
No battery management system is required
PowerCells Last a Lifetime
​
Our high-fault tolerable power storage cell system is based on Nickel—Iron (NiFe) battery technology with a number of advancements and modifications. The active materials are held in nickel-plated steel tubes or perforated pockets. It is an extremely robust battery which is tolerant of abuse, (overcharge, over—discharge, and short—circuiting) and can last a lifetime, if so treated.
The system can be continuously charged and is used in commercial power backup situations and lasts for many decades even in operations with high-vibration, high and low temperatures and other physical stress. Our NiFe PowerCell have no contaminants requiring special handling for hazardous materials.
The PowerCell can be discharged and charged endlessly without any degradation over time and never loses capacity even if the PowerCell is completely discharged and can be recharged to 100% capacity. No other system can do this.
Unlike other storage systems, the entire capacity is usable. The system cannot be overcharged, and it does not overheat. It performs well under adverse conditions of charging and discharging several times a day. PowerCell have infinite charge/discharge cycling capability as opposed to a maximum of 5,000 cycles such as Lithium-ion — his means the PowerCell never needs to be replaced.
Unlike other battery storage systems, the PowerCell can be completely discharged without shortening the life cycle. Another uniqueness is the ability to charge at a higher voltage to completely recharge in as little as 30 minutes. This function is especially effective with advanced wind turbine generator. The wind turbine has a unique ability to produce very high amounts of electricity. These unusual properties make selecting and configuring the green energy systems, inverter and charge controller quite different from other storage systems. Our engineers work with each and every customer to make sure all components are harmonized to ensure optimum performance.
Keep in mind, the quick charge capability. Lead times for other systems is a 12-16 hours and up to 36-48 hours for large systems. Compare that to as little as 30 minutes for our PowerCell.